2018 Ford Transit Custom Door Panel Removal Guide

Are you looking to remove the door panel on your 2018 Ford Transit Custom? Whether you need to fix a broken component or upgrade your speakers, knowing how to properly remove the door panel is essential. In this guide, we will walk you through the step-by-step process to ensure a successful removal without causing any damage.

Tools and Materials You Will Need

• Trim panel removal tool
• Torx screwdriver set
• Phillips screwdriver
• Door panel clip remover
• Plastic pry tool
• Shop rag
• Container for storing screws

Step 1: Prepare for Door Panel Removal

Before starting the removal process, make sure the window is fully rolled up. This will prevent any obstruction during the removal. Also, disconnect the negative terminal of your vehicle's battery to avoid any electrical mishaps.

Step 2: Removing the Door Handle Cover

Use a pry tool to gently remove the cover located behind the door handle. Start from the bottom and work your way up until the cover comes off. Set it aside safely.

Step 3: Removing the Door Trim

Locate the screws holding the door trim in place. Depending on your specific model, there may be screws located underneath the armrest or inside the door handle. Use the appropriate screwdriver to remove these screws.

Next, insert a trim panel removal tool between the door panel and the door frame. Gently pry off the clips holding the panel. Take your time and work your way around the panel until all clips are released.

Step 4: Disconnecting Electrical Connections

Once the clips are released, carefully disconnect any electrical connections attached to the door panel. These connections may include power window switches, door lock cables, and speaker wires. Use a plastic pry tool if necessary to avoid damage.

Step 5: Removing the Door Panel

With all the clips and electrical connections detached, you can now lift the door panel upwards. Start from the bottom and apply even pressure to release the panel from the door frame. Be cautious not to force it or pull too hard, as this may result in damage to the panel or the clips.

Step 6: Reinstalling the Door Panel

Before reinstalling the door panel, make sure to reattach any electrical connections that were disconnected earlier. Line up the clips on the back of the panel with the holes on the door frame. Apply even pressure to secure the panel in place.

Step 7: Putting Everything Back Together

Once the door panel is securely in place, you can reinstall the door trim and screws. Carefully snap the door handle cover back into position. Finally, don't forget to reconnect the negative terminal of your vehicle's battery.

Conclusion

By following the steps outlined in this guide, you should now be able to successfully remove the door panel on your 2018 Ford Transit Custom. Remember to take your time and exercise caution to avoid any damage during the process. If you encounter any difficulties or are unsure about any step, it is recommended to consult a professional mechanic.